Unshielded eZ RJ45 CAT6/CAT7 Network Cable Connector + Rubber Boot | Push Through Crimp Connector

Unshielded eZ RJ45 CAT6/CAT7 Network Cable Connector + Rubber Boot | Push Through Crimp Connector

Description :

The EZ-RJ45 CAT6 connectors are precision engineered and will accept solid or stranded CAT6 cable.

Check the colour sequence before crimping to ensure your cable is 568A or 568B Standard

The EZ RJ45 System

• The EZ RJ45 system simplifies twisted pair terminations by allowing the wires to be inserted all the way through the EZ connector and out the front.
• This allows the technician to easily verify the proper wiring order prior to crimping, saving time and reducing waste.
• Electrical performance of the termination is optimized by pulling the EZ RJ45 connector down over the cable jacket and seating it tightly in the rear of the connector.
• Reducing the distance between the wire twists and contacts improves the performance of your cable and enable longer lengths to be run and your speed on the ethernet network will be optimal.

Common Boots used with these RJ45 Connectors

Large Boots for CAT6 / CAT7 / CAT8 Network Cables up to 8mm Cable Diameter

These RJ45 Connectors Need a Special Crimping Tool as Below to ensure the wires can be cut automatically when crimped

eZ RJ45 Crimper Tool for CAT6/CAT7 Network Connectors with Cable Passthrough

CAT6 / CAT7 Network Cable Commonly used with these connectors

100 Meter Cable Roll | CAT6 UTP CCA Unshielded 23AWG Gigabit Network Cable